I replaced the battery on my remote keyless entry on my 2000 Toyota Corolla.
It still will not open the door. Do I need to do something to reset it? Does it need to be sycronized or something? I dont have the book that came with it that tells me about the alarm system.|||this is for toyota corolla 2003.i dont nou this instruction work on yuor car or nou.Start with the key out of the ignition. Open the driver door (all other doors are closed). Driver door is unlocked (other doors don鈥檛 matter).
Perform these steps within 5 seconds
Insert the key into the ignition (don鈥檛 turn it) Pull key out
Insert the key into the ignition (don鈥檛 turn it) Pull key out
Perform these steps within 40 seconds
Close, then open the drivers door.
Close, then open the drivers door.
Insert the key into the ignition (don鈥檛 turn it) and pull it out.
Perform these steps within 40 seconds
Close, then open the drivers door.
Close, then open the drivers door.
Insert the key into the ignition and leave in the ignition.
Close the drivers door
Turn the ignition to ON (as far as you can go without cranking the engine), then back to off .
Remove the key from the ignition.
Within 3 seconds, the power door locks should lock then unlock automatically indicating successful entry into programming mode. Return to step 1 if the locks do not cycle at this point.
Perform these steps within 40 seconds
Press the lock and unlock buttons on the transmitter simultaneously for 1.5 seconds
Immediately after letting go of the lock and unlock buttons, press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door locks should lock then unlock once indicating successful programming. If the door locks cycle twice, repeat steps 6a and 6b as the remote was not accepted.
Open drivers door
Disclaimer
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment